Lenovo ThinkSystem SD530 V3 - E3.S Drive Backplane Cable Routing; Fan Cable Routing

Table 27. Rear I/O module connector
1 Rear I/O signal connector
E3.S drive backplane cable routing
Follow instructions in this section to route the cables for the E3.S drive backplane.
Notes:
• Connections between connectors;
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
• When routing the cables, make sure that all cables are routed appropriately through the corresponding
cable guides and cable clips.
Figure 130. Cable routing for E3.S drive backplane
From (system board) To (E3.S drive backplane)
Cable
1 Backplane power connector
1 Power connector
Power 2x8 to Power 2x4 (645 mm)
2 NVMe 0-1 connector (Gen5)
2 NVMe 0-1
MCIO x8 to MCIO x8 (315 mm)
Fan cable routing
Follow instructions in this section to route the cables for the fan.
Notes:
• Connections between connectors;
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
176 ThinkSystem SD530 V3 User Guide