Chassis specifications
Summary of the specifications of the ThinkSystem D3 Chassis.
Technical specifications
Table 1. Chassis technical specifications
Specification
Description
Electrical input The system supports up to three hot-swap power supplies:
• CRPS 1300-watt Titanium, input power 200-240V
• CRPS 1300-watt Platinum, input power 200-240V
• CRPS 1600-watt Titanium, input power 200-240V
• CRPS 2700-watt Titanium, input power 200-240V
• CRPS 2700-watt Platinum, input power 200-240V
Supported power supply configurations:
• 3 PSUs: 2+1 without over-subscription (optional redundancy)
• 2 PSUs: 1+1 without over-subscription (optional redundancy)
• 1 PSU: 1+0 only for 2700-watt CRPS PSU, without over-subscription
Important: Power supplies and redundant power supplies in the chassis must be of
the same brand, power rating, wattage, or efficiency level, with the same latch color.
Note: The actual power efficiency depends on system configuration.
Mechanical specifications
Important: For safety, make sure that there is no node or power supply unit installed in the chassis when
removing or installing the chassis from or to the rack.
Table 2. Chassis mechanical specifications
Specification Description
Dimension 2U rack-mounted chassis (2U2N or 2U4N)
• Height: 87 mm (3.43 inches)
• Depth: 898 mm (35.36 inches)
• Width: 448 mm (17.64 inches)
• Weight:
– Empty chassis (with chassis midplane and PSU cage): 11.83 kg (26.08 lbs)
– Maximum (with up to four 1U or up to two 2U nodes and three CRPS power
supplies installed): approximately 42.37 kg (93.41 lbs)
Note: For the supported nodes for the D3 chassis, see
“Chassis front view” on page 21.
Node technical specifications
Summary of the technical specifications of the node. Depending on the model, some features might not be
available, or some specifications might not apply.
6
ThinkSystem SD530 V3 User Guide
To Next Page
Loading...
