Figure 29. Installation of the PSU cage
After this task is completed
1. Install the chassis to the rack (see
“Install the chassis to the rack” on page 54).
2. Reinstall the nodes into the chassis (see
“Install a node to the chassis” on page 75).
3. Reinstall each PSU slot with a PSU or PSU filler (see
“Install a hot-swap power supply” on page 61 and
Installation of a PSU filler).
4. Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 171).
Node component replacement
Follow instructions in this section to remove or install the node components.
Node replacement
Follow instructions in this section to remove or install a SD530 V3 node from or to the D3 Chassis.
Remove a node from the chassis
Follow instructions in this section to remove a SD530 V3 node from the D3 Chassis.
About this task
To avoid potential danger, make sure to read and follow the safety information.
R006
72
ThinkSystem SD530 V3 User Guide
To Next Page
Loading...
