After this task is completed
• Reinstall each PSU slot with a PSU or PSU filler (see
“Install a hot-swap power supply” on page 61 and
Installation of a PSU filler).
• Reinstall the nodes into the chassis (see
“Install a node to the chassis” on page 75).
• Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 171).
• (Optional) If the chassis is to be shipped in the cabinet, follow the steps below to install the shipping
brackets on the rear to secure the chassis to the rack. Otherwise, skip this step.
1.
Align the shipping bracket with the guide holes on the rack and the chassis; then, insert the bracket
push it toward the front to engage the bracket in place.
2.
Tighten the screws to secure the shipping bracket to the chassis and the rack.
3.
Repeat the above steps to install the other rear shipping bracket.
Figure 19. Installation of the shipping brackets
Replace components in the chassis
Follow instructions in this section to remove or install components from or to the chassis.
EIA bracket replacement
Follow instructions in this section to remove or install the EIA brackets from or to the D3 Chassis.
Remove the EIA brackets from the chassis
Follow instructions in this section to remove the EIA brackets from the chassis.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
56 ThinkSystem SD530 V3 User Guide
To Next Page
Loading...
