Lenovo ThinkSystem SD530 V3 - CMOS Battery (CR2032) Replacement

b. Set up Lenovo XClarity Controller network connection through Lenovo XClarity Provisioning Manager
(see “Setting up the XClarity Controller network connection through the XClarity Provisioning
Manager” section).
c. Log in to Lenovo XClarity Controller(see “Logging in to the XClarity Controller” section).
6. If you have changed the configuration of the node, or if you are installing a different node from the one
that you removed, make sure to configure the node through the Setup utility, and you might have to
install the node operating system. For more details, see Chapter 7 “System configuration” on page 183.
7. You can place the identifying information on the pull-out label tab that are accessible on the front of the
node (see
“Identify the system and access the Lenovo XClarity Controller” on page 35).
CMOS battery (CR2032) replacement
Follow instructions in this section to remove or install the CMOS battery (CR2032).
Remove the CMOS battery (CR2032)
Follow instructions in this section to remove the CMOS battery (CR2032).
About this task
To avoid potential danger, make sure to read and follow the safety information.
S004
CAUTION:
When replacing the lithium battery, use only Lenovo specified part number or an equivalent type of
battery recommended by the manufacturer. If your system has a module containing a lithium battery,
replace it only with the same module type made by the same manufacturer. The battery contains
lithium and can explode if not properly used, handled, or disposed of.
Do not:
• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
S005
CAUTION:
The battery is a lithium ion battery. To avoid possible explosion, do not burn the battery. Exchange it
only with the approved part. Recycle or discard the battery as instructed by local regulations.
Attention:
80
ThinkSystem SD530 V3 User Guide