Lenovo ThinkSystem SD530 V3 - Hot-Swap Power Supply Replacement

Procedure
Step 1. Align the left EIA bracket with the screw holes on the left of the chassis; then, secure it to the
chassis with the screws.
Step 2. Repeat the same step to secure the right EIA bracket to the right of the chassis.
Figure 21. Installation of the EIA brackets
After this task is completed
• Install the chassis to the rack (see
“Install the chassis to the rack” on page 54).
• Reinstall each PSU slot with a PSU or PSU filler (see
“Install a hot-swap power supply” on page 61 and
Installation of a PSU filler).
• Reinstall the nodes into the chassis (see “Install a node to the chassis” on page 75).
• Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 171).
Hot-swap power supply replacement
Follow instructions in this section to remove or install a hot-swap power supply unit (PSU).
Remove a hot-swap power supply
Follow instructions in this section to remove a power supply unit (PSU).
About this task
To avoid potential danger, make sure to read and follow the safety information.
S001
58 ThinkSystem SD530 V3 User Guide