Figure 124. Removal of the top cover
After this task is completed
1. Install a replacement unit (see
“Install the top cover” on page 170).
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install the top cover
Follow instructions in this section to install the top cover.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
• Read
“Installation Guidelines” on page 41 and “Safety inspection checklist” on page 42 to make sure that
you work safely.
• Make sure that all cables, adapters, and other components are installed and seated correctly and that
there are no loose tools or parts left inside the node.
• Make sure that all internal cables are correctly routed (see
Chapter 6 “Internal cable routing” on page 173).
Procedure
Step 1. Align the top cover guide pins with the guide holes on the node; then, place the top cover onto the
top of the node and slide it towards the front of the node until it engages with the node.
Step 2. Check and make sure that the button on the side of the top cover is in locked position.
170
ThinkSystem SD530 V3 User Guide
To Next Page
Loading...
