Lenovo ThinkSystem SR860 - Install the Top Cover

Figure 93. 4U PCIe riser assembly installation
Table 81. Guide pin and assembly filler
1 Guide pin 2 4U PCIe riser assembly filler
After installing a 4U PCIe riser assembly, complete the following steps:
1. Install the top cover (see
“Install the top cover” on page 128).
2. If the server is installed in a rack, reinstall the server into the rack.
3. Power on the server and any peripheral devices.
Install the top cover
Use this procedure to install the server top cover.
S014
128 ThinkSystem SR860 Setup Guide