• 2.5-inch SATA/SAS 8-bay backplane (referred to as “8-bay backplane”)
• 2.5-inch AnyBay 8-bay backplane (referred to as “AnyBay backplane”)
4U PCIe riser assemblies can be installed when the PCIe slot 3 or 13 are not occupied by PCIe adapters,
make sure the slots for 4U PCIe riser cards are available before the riser card installation.
Cable routing for 2.5-inch drives to one backplane
Use this section to route cables for 2.5-inch drives to one backplane.
Following is the list of combinations of cable routing for 2.5-inch drives to one backplane.
•
“Connecting signal cables to one backplane” on page 33
– “One 8-bay backplane” on page 34
– “One AnyBay backplane” on page 35
– Two processors installed
– Four processors installed
Connecting signal cables to one backplane
When there is one backplane installed, see the following illustrations for cable routing.
Chapter 2. Server components 33
To Next Page
Loading...
