Chapter 4. System configuration
Complete these procedures to configure your system.
Note: Some Lenovo systems management applications, including XClarity Administrator, XClarity
Controller, XClarity Energy Manager, and XClarity Essentials, are not supported by ST50 V2.
Update the firmware
Go to Lenovo Datacenter Support site for the latest firmware update package.
To update the firmware from a flash device, complete the following steps:
1. Go to
https://datacentersupport.lenovo.com/tw/en/products/servers/thinksystem/st50v2/downloads/driver-
list/
. All the downloadable firmware packages for ST50 V2 are available on this site.
2. Download the latest version of firmware update packages.
3. Follow the instructions enclosed in the package to update the firmware.
Note: Perform the firmware update in operating system accordingly to the instructions.
Configure the firmware
Read this section to learn about how to set up the firmware for the server.
Starting the Setup Utility program
Follow this procedure to start the Setup Utility program.
To start the Setup Utility program, complete the following steps:
Step 1. Power on or restart the server.
Step 2. Before the operating system starts up, repeatedly press and release F1. It will lead to the text-
based BIOS interface.
Note: If a BIOS password has been set, the Setup Utility program will not open until you enter the
correct password.
Changing the display language of the Setup Utility program
The Setup Utility program supports three display languages: English and simplified Chinese.
Step 1. Start the Setup Utility program, see “Starting the Setup Utility program” on page 101.
Step 2. From the main interface, locate Language and press Enter.
Step 3. Select the display language.
Enabling or disabling a device
This section provides information about how to enable or disable hardware devices, such as USB connectors
or storage drives.
To enable or disable a device, complete the following steps:
© Copyright Lenovo 2022, 2022 101
To Next Page
Loading...
Need help?
General
