Lenovo ThinkSystem ST50 V2 Setup Guide

About this task
Attention:
• Read “Safety inspection checklist” on page 43 and “Installation Guidelines” on page 41 to ensure that you
work safely.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
AU3iY3F7lq3qfqr5caGbIu
.
After you finish
Step 1. Align the M.2 drive retainer with the three slots on chassis, and lower the retainer into the chassis;
then, slide the retainer toward the 2.5-inch drive to secure it in place.
Figure 69. Installing the M.2 drive retainer
About this task
Install an M.2 drive, see “Install an M.2 drive” on page 84.
Install a PCIe adapter
Follow this procedure to install a PCIe adapter.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
86 ThinkSystem ST50 V2 Setup Guide

Lenovo ThinkSystem ST50 V2 Specifications

General

Memory	Up to 128 GB DDR4
Memory Slots	4 DIMM slots
Form Factor	4U Tower
Processor	Intel Xeon E-2300 series
Storage	Up to 4 x 3.5" or 8 x 2.5" drives
Storage Controller	Onboard SATA controller
RAID Support	RAID 0, 1, 5, 10
Expansion Slots	1x PCIe 3.0 x4
Network	1x Gigabit Ethernet port
Operating Systems Supported	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi
Management	Lenovo XClarity Controller