Cable routing for the power supply unit
Read this section to learn about cable routing for the power supply unit.
Figure 20. Cable routing for the power supply unit
Table 18. Cable routing for the power supply unit
From To
1 Micro-fit to 1X15P and 1X4P Y-splitter power cable
(4-pin or 8-pin SATA connector for processor power)
Processor power connector
Note: The 2x2 pins marked in grey are for 300W PSU.
2 Micro-fit to 1X15P and 1X4P Y-splitter power cable
(15-pin connector for system power)
System power connector
Note:
1 and 2 are parts of the same Y-splitter cable.
Make sure to follow the “Cable routing guidelines” in “Internal cable routing” on page 19.
For the system-board connector locations, see “System board components” on page 18.
28
ThinkSystem ST50 V2 Setup Guide
To Next Page
Loading...
