Drive bay Types of drive supported
1 Bay 1 3.5-inch simple-swap drive
2 Bay 2 2.5-inch simple-swap drive
3 Bay 3 3.5-inch simple-swap drive
4 Optical drive bay 9mm slim SATA Optical disk drive
Install server hardware options
This section has instructions for performing initial installation of optional hardware. Each component
installation procedure references any tasks that need to be performed to gain access to the component
being replaced.
Installation procedures are presented in the optimum sequence to minimize work.
Remove the server from the rails
Follow this procedure to remove the server from the rails.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
S014
CAUTION:
Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is
authorized to remove the covers where the label is attached.
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
Chapter 3. Server hardware setup 47
To Next Page
Loading...
