Cable routing for drive bay 3
Read this section to learn about cable routing for the drive in bay 3.
Figure 15. Cable routing for drive bay 3
Table 13. Cable routing for drive bay 3
Cable From To
1 SATA cable 1 latch (520 mm)
Bay 3 drive signal connector
SATA 3 connector
2 Slim ODD, second 3.5-inch drive
and 2.5-inch drive power cable ( 300
mm + 210 mm + 110 mm)
Bay 3 drive power connector SATA power 1 connector
Make sure to follow the “Cable routing guidelines” in “Internal cable routing” on page 19.
For the system-board connector locations, see “System board components” on page 18.
Chapter 2. Server components 23
To Next Page
Loading...
