Lenovo ThinkSystem ST50 V2 - Page 52

About this task
Attention:
• Read “Safety inspection checklist” on page 43 and “Installation Guidelines” on page 41 to ensure that you
work safely.
• Turn off the server and peripheral devices, and disconnect the power cords and all external cables, see
“Power off the server” on page 99.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
AU3iY3F7lq3qfqr5caGbIu
.
Procedure
Note: Your system might looks slightly different from the illustration below.
Step 1. Remove the two M6 x 16 screws on the front of the rack cabinet.
Figure 31. Removing the screws on the front of the rack cabinet
Step 2. Remove the server from the rails.
a.
Slide and pull the rack server tray out of the rack cabinet.
b.
Lift the server out of the tray.
48
ThinkSystem ST50 V2 Setup Guide