Lenovo ThinkSystem ST50 V2 - Page 64

Figure 41. Circuit board on the drive
Step 1. Install a 3.5-inch or 2.5-inch drive to the retainer
a.
Slightly tear both sides of the retainer apart.
b.
Align the four holes on the drive with the corresponding pins on the retainer; then, fit the
drive into the retainer.
Note: The drive connectors should face the retainer handles.
Install a 3.5-inch drive into the retainer
Figure 42. Installing a 3.5-inch drive into the retainer
60 ThinkSystem ST50 V2 Setup Guide