Lenze 8400 motec - Page 57

Error messages
Possible causes and remedies
57
Lenze · Decentralised frequency inverter 8400 motec (AS-Interface option) · EDS84DMOTASI EN 4.0 - 09/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Module internal/watchdog error [0x01bc6010]
Drive PDO communication timeout [0x01bc6011]
Module offline [0x01bc6100]
Module PDO communication timeout [0x01bc6101]
Response (Lenze setting printed in bold) Setting: C01501/1 / C01503 ( adjustable response)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Device internal MCU error • Switch the voltage supply of the Inverter Drive 8400
motec and the AS-i network off and on again.
• If this error continues to occur, please contact the
Lenze service. (it might be necessary to replace the
Communication Unit.)
Response (Lenze setting printed in bold) Setting: C01501/2 / C01503 ( adjustable response)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Voltage supply of the Inverter Drive 8400 motec
interrupted.
• Check wiring and terminals.
• Check whether the Inverter Drive 8400 motec is
addressable via the diagnostics interface.
• Switch the voltage supply of the Inverter Drive 8400
motec off and on again.
• If this error continues to occur, please contact the
Lenze service. (it might be necessary to replace the
Communication Unit.)
Response (Lenze setting printed in bold) Setting: C01501/1 / C01503 ( adjustable response)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
• Device internal MCU error
• AS-i voltage supply interrupted.
• Connection between the Communication Unit and
the Drive Unit defective.
• Check wiring and terminals.
• Switch the voltage supply of the AS-i network off and
on again.
• If this error continues to occur, please contact the
Lenze service. (it might be necessary to replace the
Communication Unit.)
Response (Lenze setting printed in bold) Setting: C01501/1 / C01503 ( adjustable response)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
• AS-i voltage supply interrupted.
• Connection between the Communication Unit and
the Drive Unit defective.
• Check wiring and terminals.
• Switch the voltage supply of the AS-i network off and
on again.
• If this error continues to occur, please contact the
Lenze service. (it might be necessary to replace the
Communication Unit.)