Lenze 8400 TopLine C - Parameter Setting in the FB Editor View

Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05 11
2 Features of the technology application
2.7 Parameter setting in the FB Editor view
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.7 Parameter setting in the FB Editor view
You can make the settings of the application-specific parameters directly in the FB Editor. This has
the advantage that the signal flow can be traced. The interaction of the modules becomes clear.
Moreover, you can reconfigure the I/O interconnection using the FB Editor and carry out an online
monitoring of the application running in the device (e.g. for diagnostic purposes).
• The icon in the head of the module, a double-click on the module, or the Parameter...
command in the Context menu of the module serve to open the parameterisation dialog or the
parameter list for the module.
• Colour codes and comments support you in handling the FB Editor.
• The areas highlighted in turquoise represent the "user interface". If required, the pre-
assignment of the I/O terminals can be adapted here and a control via the fieldbus interface
(MCI) can be established.
• In the areas highlighted in yellow, application-specific settings are required.
 Detailed information on how to work with the FB Editor can be found in the reference
manual/online help of the controller in the chapter "Working with the FB Editor".