5 Appendix: Action types for the positioning sequence control
5.7 Count
52
Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.7 Count
For counting processes, 8 actions of the "Count" type are provided. Each time the action is processed,
the counter content of the corresponding counter is increased or decreased by the step value set
(counting up or down).
• The comparison operation enables a conditional branch depending on the current counter
content.
• For setting a counter to a starting value, 5 actions of "counter setting
" type are available.
Parameter Possible settings Info
Counter No.
(C01444/1...5)
0Counting deactivated
(Sequence step is processed.)
Selection of the counter
1Counter 1
... ...
5Counter 5
Comparison operation
(C01448/1...8)
1 Counter content = comparison value If the comparison operation is true, a
branch to the jump destination set is
executed. Otherwise the next step in
the sequence table is processed.
2 Counter content > comparison value
3 Counter content ≥ comparison value
4 Counter content < comparison value
5 Counter content ≤ comparison value
Jump destination
(C01447/1...8)
0 Sequence step Jump destination if the comparison
operation is true.
1...100 Step 1 ... 100
Current counter content
(C01443/1...5)
-2147483647 2147483647 Read only
Step value
(C01445/1...8)
-2147483647 2147483647 Value by which the counter is
increased or decreased.
Initialisation: 1
Comparison value
(C01446/1...8)
-2147483647 2147483647 Value to which the counter is
compared.
Initialisation: 0
To Next Page
Loading...
