Lenze 8400 TopLine C - Step 4: Create the Positioning Program (Sequence Table)

Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05 23
3 Short setup of the technology application
3.5 Step 4: create the positioning program (sequence table)
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.5 Step 4: create the positioning program (sequence table)
The sequence table is parameterised in the parameterisation dialog for the L_Sequencer_1 FB.
The parameterisation dialog is divided into four main areas:
 Note!
In the default setting, the sequence table already contains a small "positioning
program", which rotates the axis first by 360° in clockwise direction and then by 360° in
counter-clockwise direction.
Main area Info
 Sequence table (sequencer) The sequence table consists of 100 fields which can be filled with actions.
 Selection of action type In this area, the different action types are provided for selection, by means of
which the sequence table can be filled.
 Comment on the action Optionally, a comment on the action selected can be entered here.
 Action parameters In this area, the parameters for the action selected are set.