Lenze 8400 TopLine C - Step 1: Load Position Sequencer Technology Application

Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05 15
3 Short setup of the technology application
3.2 Step 1: Load "Position Sequencer" technology application
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.2 Step 1: Load "Position Sequencer" technology application
In the Lenze setting, the inverter uses the "Speed actuating drive" technology application integrated
in the device. Execute the following steps to use the "Position Sequencer" technology application
instead:
1. Select the controller in the Project view.
2. If there is still an online connection to the controller:
Click the icon to go offline again.
(the application can only be selected offline.)
3. Click the icon to select another application.
The Insert application dialog box appears:
4. In the left field, select the "Packages"  "Applications" category.
5. In the right field, select the "Position Sequencer" application.
6. Activate the Except motor data parameters option in order that the settings of the motor data
parameters made before will not be overwritten.
7. Press Complete to close the dialog box again and load the selected application into the
»Engineer« project.
8. Confirm the prompt on whether the current application is to be replaced by the "Position
Sequencer" application with Yes.