Lenze 8400 TopLine C - End

Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05 55
5 Appendix: Action types for the positioning sequence control
5.10 End
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.10 End
In order to define the program end within the sequence table, one action of the "End" type is
provided. If, at the L_Sequencer FB, the bStart input is reset to FALSE while the positioning program
is running, processing is only continued until the program end.
The "End" action has no individual parameters.