Lenze 8400 TopLine C - Variable Branch

Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05 49
5 Appendix: Action types for the positioning sequence control
5.4 Variable branch
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.4 Variable branch
For variable branching (jumps), two actions of "variable branching" type are available.
• Branching to one of 20 possible branching destinations is carried out as a function of the input
value of wBranch1 or wBranch2 at the time of processing.
•The input value of wBranch1 defines branching for action 1.
•The input value of wBranch2 defines branching for action 2.
• If the input value is 0 or greater 20, the next step in the sequence table is processed.
• In the default setting, the wBranch1 input is linked with MCI process data input word 3. Pre-
assignment of the process data input words ( 18)
• In the default setting, the wBranch2 input is not connected.
For entering the branch destinations, click the Set Up Branch... button in the parameterisation
dialog.
Parameter Possible settings Info
Branch destination
(C01418/1...2 - C01437/1...2)
0 Branching deactivated
(The following step in the sequence
table is processed.)
Branch destinations for input values
1 ... 20 of wBranch1...2.
1...100 Step 1 ... 100