4 Detailed functions of the technology application
4.2 Basic drive functions (MCK)
34
Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
How to go to the parameterisation dialog of the basic "Manual jog" function:
1. Open the parameter list for the LS_MotionControlKernel SB.
2. In the Block Parameters List... dialog box on the Application parameters tab, select the
"Manual Jog" entry in the upper list field.
Parameter Info Lenze setting
Value Unit
C01230 MCK: Manual jog setting Bit coded
C01231/1 Manual jog: speed 1 360.0000 units/s
C01231/2 Manual jog: Speed 2 720.0000 units/s
C01232/1 Manual jog: Acceleration 3600.0000 units/s2
C01232/2 Manual jog: Deceleration 10000.0000 units/s2
C01233/1 Manual jog: S-ramp time 0.000 s
C01235/1 Waiting time 2nd speed 5.000 s
C01234/1 Manual jog: Breakpoint 1 0.0000 unit
C01234/2 Manual jog: Breakpoint 2 0.0000 unit
C01234/3 Manual jog: Breakpoint 3 0.0000 unit
C01234/4 Manual jog: Breakpoint 4 0.0000 unit
To Next Page
Loading...
