Lenze E94AYCEO - Communication Channels

Lenze · E94AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 12/2013 · TD17 48
7 Data transfer
7.1 Communication channels
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.1 Communication channels
EtherNet/IP transmits parameter data and I/O data between the host system (scanner) and the
drives (adapters) connected to the fieldbus. The data are transmitted via corresponding
communication channels depending on their time-critical behaviour.
The I/O data channel transmits I/O data by means of "implicit messages".
• The drive is controlled by means of the I/O data.
• The transmission of I/O data is time-critical.
• I/O data are transmitted cyclically between the host system (scanner) and the drives (adapters)
(permanent exchange of current input and output data).
• The host system (scanner) has direct access to the I/O data (the data are, for example, stored
directly in the I/O area).
• In the case of Servo Drives 9400, maximally 32 data words (max. 64 bytes) for each direction can
be exchanged.
• I/O data are not stored in the drive.
• I/O data are e.g. setpoints, actual values, control and status words
The parameter data channel transmits parameter data by means of "explicit messages".
• The transmission of parameter data is usually not time-critical.
• Examples of parameter data are operating parameters, motor data, and diagnostic information.
• The parameter data channel provides access to all Lenze codes.
• Parameter changes must be saved via code C00002 of the Servo Drive 9400.
 Note!
The terms "input" and "output" refer to the point of view of the scanner:
• Input data is produced by the adapter and consumed by the scanner.
• Output data is produced by the scanner and consumed by the adapter.