Lenze E94AYCEO - Setting Via Codes in the Engineer

Lenze · E94AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 12/2013 · TD17 40
6 Commissioning
6.3 Setting the IP configuration of the Servo Drive 9400
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.3.2 Setting via codes in the »Engineer«
You can also set the IP parameters manually in the »Engineer« under the Settings tab. The values
will be transferred to the corresponding codes.
 How to activate changed settings in the »Engineer«:
1. Execute device command C00002 = "11: Save all parameter sets".
The current IP configuration is stored in the memory module of the drive.
2. Carry out a "Type 0 reset" for the Identity Object (1 / 0x01)
( 121) of the node, or switch the
voltage supply of the communication module off and on again.
Settings Description
IP Config Control Selection (C13005
/ C14005) of how the IP configuration is to be effected:
• 0: The IP configuration currently stored in the communication module is
used.
• 1: The IP configuration is assigned by a BOOTP server using the BOOTP.
• 2: The IP configuration is assigned by a DHCP server using the DHCP.
IP Address Setting the IP address (C13000
/ C14000)
Subnet mask Setting the subnet mask (C13001
/ C14001)
Gateway Address Setting the gateway address (C13002
/ C14002)
Multicast IP Start Address Setting of the multicast IP start address (C13006
/ C14006)
Setting the multicast configuration
( 43)
Multicast Config TTL Value Setting of the multicast TTL value (C13019
/ C14019)