Lenze E94AYCEO - Page 94

Lenze · E94AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 12/2013 · TD17 94
13 Parameter reference
13.2 Parameters of the communication module for slot MXI1
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C13018
C13019
C13020
C13021
Parameter | Name:
C13018 | Multicast Config Alloc Control
Data type: UNSIGNED_8
Index: 11557 = 0x2D25
Selection for multicast IP addressing via the instance attribute 9 (Mcast Config) in the TCP/IP Interface Object (245
/ 0xF5) ( 132)
Selection list (Lenze setting printed in bold)
0 Default Allocation Algorithm
1 Multicast IP Start Address
 Read access  Write access  CINH  PLC STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT
Parameter | Name:
C13019 | Multicast Config TTL Value
Data type: UNSIGNED_8
Index: 11556 = 0x2D24
Setting of the multicast TTL value for the validity time of data packets in the EtherNet/IP network
(Instance attribute 8 (TTL Value) in the TCP/IP Interface Object (245 / 0xF5)
( 132))
Setting range (min. value | unit | max. value) Lenze setting
1 255 1
 Read access  Write access  CINH  PLC STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT
Parameter | Name:
C13020 | Multicast Config Num Mcast
Data type: UNSIGNED_8
Index: 11555 = 0x2D23
Used to set how many multicast IP addresses will be assigned.
(Instance attribute 9 (Num Mcast) in the TCP/IP Interface Object (245 / 0xF5)
( 132))
Setting range (min. value | unit | max. value) Lenze setting
1321
 Read access  Write access  CINH  PLC STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT
Parameter | Name:
C13021 | Quality of Service (VLAN-Tagging)
Data type: UNSIGNED_8
Index: 11554 = 0x2D22
Used to set whether QoS tags will be used for the prioritisation of the data packets to be transferred.
(Instance attribute 1 (802.1Q Tag Enable) in the Quality of Service (QoS) Object (72 / 0x48)
( 130))
Selection list (Lenze setting printed in bold)
0 802.1Q Tag Disable
1 802.1Q Tag Enable
 Read access  Write access  CINH  PLC STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT