Lenze E94AYCEO - Page 84

Lenze · E94AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 12/2013 · TD17 84
12 Error messages
12.2 Possible causes and remedies
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
EtherNet/IP: Internal error [0x00c86100]
EtherNet/IP: Internal error [0x00c86101]
EtherNet/IP: Invalid parameter set [0x00c8641f]
EtherNet/IP: Lenze setting loaded [0x00c86420]
EtherNet/IP: Internal mapping error [0x00c86430]
EtherNet/IP: Invalid IP parameters [0x00c86533]
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Communication module is defective. Send communication module with error description to
Lenze.
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Communication module is defective. Send communication module with error description to
Lenze.
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
No active parameter set could be loaded. • Download application again (including module).
• Send communication module together with a
description of the fault to Lenze.
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Access to parameter set in memory module via standard
device was not successful.
• Download application again (including module).
• Send communication module together with a
description of the fault to Lenze.
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The entered I/O data mapping is invalid.
• An object not supporting the required properties has
been specified.
• More than 64 bytes of data have been mapped.
Repeat I/O configuration in the »Engineer«
( 55).
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
One or more IP parameters are faulty. Check and correct IP configuration.
Setting the IP configuration of the Servo Drive 9400
( 37)