Lenze E94AYCEO - Page 86

Lenze · E94AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 12/2013 · TD17 86
12 Error messages
12.2 Possible causes and remedies
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
EtherNet/IP: Class 3 Connection Closed [0x00c88143]
EtherNet/IP: Duplicate IP address [0x00c88273]
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Scanner has closed a "Class 3" connection. Check scanner functionality.
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
An IP address has been allocated twice within the
network. The addresses of the network nodes must differ
from each other.
Correct IP address (C13000
/ C14000).
Setting the IP configuration of the Servo Drive 9400
( 37)