21 CMVETH01B
Commissioning
Figure 16: RSLogix 5000 Window (SoftLogix 5800)
2. For CompactLogix and SoftLogix only:
Right click on [Backplane, 1789-A17/A Virtual Chassis] to choose the Ethernet adapter.
Select [New module] and the “Select Module” dialog box will open.
Under the “By Category” tab, click the [+] icon to expand the [Communications] folder
Select the EtherNet/IP scanner or bridge used by your controller. (Ex SoftLogix5800 EtherNet/IP)
Then select the major revision of your controller’s firmware in the Major Revision box.
Figure 17: Ethernet Adapter selection (SoftLogix 5800)
To Next Page
Loading...
