Lenze SX-1 - Page 124

8.3
When entering the Program instructions,
you should in general use the tollowing
sequence ot keystrokes:
1. Press the required instruction key,
e.g. WAll
2. Press the MODE key until the
specific iristruction in the group is
di spl ayed.
The instruction is displayed (e. g. from a group of
similar instruction, in this casethe „Wait“ group), but
without values.
Here, for example, if the MODE key is pressed
twice: WAIT 1 = L appears. The value following
input 1 is empty.
At the place tor value entry, the appropriate number
3. P ress E NIE R. 01 dashes ———— appears (the last one blinking).
4. Enter the value with the numeric
keypad, e.g. here type 2, and press
ENTER.
The value is accepted. the display moves up one
line, making room for the next instruction.
Note:
When you have selected the IF, POS and
SET instruction groups, you may select
the sub-groups using the NEXT and MODE
keys.
IF 1.. H Lvv (hww)
L
7IFF ..H Lvv(Uww) Li7j
IFC . . aaaa Lvv
IFI .. LLvv(Uww)
IFF..LLvv(Uww)
IFC..aaaaUww
8/24
Lanze