Lenze SX-1 - Page 130

8.3
DELETE ________________
Pressing this key deletes the instruction at working line 3.
INSERT
When this key is used, the instruction in working line 3 is scrolled up, and a space is inser -
ted after it, indicated with a“>“ symbol.
The empty line is maintained after every instruction is entered, so that several instructions
may be entered in succession. Press the enter key to leave this tunction.
TEA CH
When this key is used, the instruction in working line 3 is scrolled up, and a positioning
instruction PA is inserted after it. lt the POS key is now pressed, the present Actual Position
value is read, and a position instruction with the same value is inserted by pressing the
ENTER key.
The TEACH-Function is then completed.
With the TEACH-Function, it is possible to drive to each position required in the Manual-
External mode, and then enter these into the Program.
LABEL
Any instruction in the Program may be given a Label. This is necessary to define the
destination address tor a jump instruction.
The label number must be entered by pressing the LAB key BEFORE entry ot an instruc-
tion in line 2. The label number is entered.
Every label L-instruction must be tollowed by the label number and then a program
instruction, e. g.
L 13
VEL 90%
________________________________— 8/30
Lanze