Lenze SX-1 - Error Codes and Remedies (11-30)

9.
System set to Endless mode:
does not allow Absolute
positioninci
Two operating modes selected!
Ouput not present
Mode selection incorrect
Home position no found
Excessive positioning time
Change ot Acceleration mode
not allowed
Not used
lnstruction (present) not allowed,
e. g. Override with sin
2 mode
lncorrect instruction
Arithmetic overflow
Stack Overflow
Stack Underflow
Program not present
Program memory tull
Not used
lnvalid Parameter data
Velocity too high
Excessive Following Error
Not used
Change Program
Only in version 5.X
Change Program
Check coding switch
Home
Position window, KV value too
small
Check Program
Check Program
Internal error
Check input data
Check Program; memory capaci -
t exceeded ________________
Check Program
Provide Program; check Para-
meter PO - Program selection
Check Parameters with respect
to data limits
Check Parameters with respect
to data limits
Check Parameters with respect
to data limits
9/2
11
12
13
14
15
16
17
18
19
21
22
23
24
26
27
30
Lanze