Lenze SX-1 - Error Codes and Remedies (31-45)

9.
31 Acceleration max. too small Check Parameters with respect
to data limits
32 Acceleration max. too large Check Parameters with respect
to data limits
33 Marker (Zero) pulse missing
when Homing
34 lnvalid command over comms.
link
Check Parameter P2 (Encoder
count)
Only possible under DNC
co ntro 1
35 Home switch not found Check switch
36 Position teedback detects no Check encoder, encoder cables,
motion and encoder coupling
37 Not used
Error Codes 38 through 44 cover error which
terpolating mode.
can only occur when coupled in in
38 Slave error whilst inter- Read error code on Slave LED
polatin~ (on Master LED) and correct
39 Master error whilst inter- Read error code on Master
polating (on Slave LED) LED and correct
40 lnstruction only tor Master Check Program
axis
41 lnstruction only tor Slave Check Program
axis
42 Initialising ot Master detects Internal error
error
43 lncorrect information whilst Internal error
interpolating, in Slave
44 lncorrect information whilst Internal error
interpolating, in Master
45 Parameters missing; Error
when Saving Parameters or
After initiating a SAVE-tunc
tion, the SX-1 must remain
Programs switched on tor sufticient time
to ensure safe programming
ot the EEPROM
- 9/3 __
Lanze