Lenze SX-1 - Correcting an Error

9. -
Correcting an Error
There are three types ot error and error correction as tollows:
a) Errors resulting trom unusable Parameter data read upon switch-on. They can be
corrected only by the entry ot new or corrected Parameters.
b) Errors arising when the SX-1 is executing a Program, or being manually operated.
Program execution is stopped. The error may be cancelled by positive edge on Input
El (Enable SX-1).
c) Serious errors which attect the tunctioning ot the Position control (Errors E03, E04,
E05). As weIl as reporting the error, the drive Enable is removed. Program execution
is stopped. lt the cause ot the error is removed, and the error is cancelled as in b),
the drive is enabled and the position loop restored.
All error outputs result in the opening ot the „NC Healthy“ output contact. The drive must
thereby be stopped and secured, e. g. power removed and the brake appliec~ (lt titted).
See also Chapter 6.
—___________ -- 9/4
Lanze