Lenze SX-1 - 3.1.2 Technical Data for the SX-1; Interface Connections

3.1.2 ~-
3.1.2 Technical Data for the SX-1
Weight 3,5 kg
Environmental Temperature
- Operating 0 0 450
(Up to 55
0C with forced ventilation)
- Storage -20 0 +70 0C
Humidity 10 ... 90% relative humidity, non-condensing
Supply AG 110/220V, +10%, -15%; 50/60 Hz
Power Consumption 30 VA
Protection IP 20
Processor Motorola 6809
Program Storage EEPROM 8 kByte
Largest Single Program 2000 Byte
Interface Connections
Gontroller Interface X2
Option:
lnputs and Outputs using external 24 V DC supply
12 inputs with opto-isolation; 5 ms time constant;
5 inputs are user-programmable
4 inputs used to select operating mode (encoded).
Software Version 4.XX
8 inputs used lto select operating mode (non-enco -
ded). Software Version 5.XX
Input current 5 mA per input
11 outputs in total
9 opto-isolated; short circuit protected; maximum bad
100 mA
8 of which are user-programmable,
1 dedicated to „Drive in Position“
±10V into 10 k=2 minimum with 13 bit D/A convertor
Resolution 2.5 mV approx;
2 relay contact outputs for „Fault“ and „Drive Enable‘~
1 max 100 mA
4 opto-isolated inputs with 1 ms time constant for
„Enable NC System“ and „Cancel Fault“.
End-of-Travel Limit Switches + and - (or Right and
Left)
Reference (Home) Position Switch
Analog Override - 0 to 10 V corresponds to a Speed
Overnde oi 0-125 %
-~ 3/2
Lanze
Parallel Interface Xl
lnputs (E)
Outputs (A)