Lenze SX-1 - P30-P32 Motion and Transmission Parameters

7.1.2
P30: Limit Switch Mode
Limit Switch contact mode can be selected:
0 = Inverse
1 = Normal
P31: Variable Transmission Mode
Unit: Quantity of SX-1 with PT-1.
Range: 0 ... 64
With the Variable Data menu, variable values may be changed, and when correct, sentto
the SX-1 by pressing the ENTER key. lt several axes are connected to the PT-1, then
normally only the selected axis is supplied with data. lt you wish to supply data in parallel
to several SX-1 controls, then use Parameter P31.
For example:
P31 = 1
P31 = 2
Variable sent only to selected Axis.
Variable sent to Axis No. 0 and No. 1
P32: Units per Revolution (U/rev)
Units (tor P32): Units per Revolution
Range: 0.000 ... 99999.999
The number of „Units per Revolution“ is used, together with the instruction „Position
Absolute/Direct Positioning“ (see Chapter 8) to reach required position by the shortest
route.
For a given final position, the shortest distance (clockwise or anti-clockwise) will depend
on the number of units per revolution.
7/24
Lanze