Lenze SX-1 - P33-P36 Variable Definition Parameters

7.1.2
P33: Name of Variable ~
(N-V~)
Up to 6 characters may be entered:
Example: Speed
Details ot Entry: See Chapter 7.2
P34: Format of Variable ~ (F-V~O)
The MODE key selects the following formats:
xxx
xxxxx
xxxx.x
xxxxx.xxx
torvelocity, acceleration, deceleration (in %)
for counter values (increments) and delay periods (ms)
for velocities in direct values, e. g. mm/s, m/min etc.
fordistances, angles etc. in direct values
P35: Lower Limit of Variable ~ (L-V~)
(Low Limit: L-V~~)
Input value format depends on P34.
P36: Upper Limit of Variable ~ (H-V~)
Input value format depends on P34.
This description is valid for all variables VOO to Vi 4, using P37 to P40 for VOl etc.
____ 7/26 __
Lanze