Commissioning
Leuze electronic SOLID-2 39
TNT 35/7-24V
Review-Stand, , 8. April 2015
DEUTSCHENGLISHFRANÇAISITALIANOESPAÑOLNEDERLANDS
7.2 Aligning transmitter and receiver
Transmitter and receiver must be mounted in place at the same height or, if they are used
horizontally, at the same distance from the reference level.
7.2.1 Optimized aligning with the aid of the Receiver’s 7-segment display
The distinction between protecting field is free (channel number is shown continuously)
and the weak signal mode (channel number is flashing) can be used as a convenient
alignment tool.
When the components are already almost aligned it is recommended to improve the
alignment e.g. by turning the receiver. Turn the receiver with slightly loosened brackets
until the 7-segment display starts to blink. Memorize this position. Now turn the receiver in
the opposite direction until the display lights constantly and further, until it is blinking
again. Now turn the receiver back in between the two positions determined. Screw the
receiver firmly into place to prevent turning. Proceed with the transmitter in the same
manner.
To Next Page
Loading...
