Leuze electronic SOLID-2 Series - Symbols and Terms

General
6 SOLID-2 Leuze electronic
Review-Stand, , 8. April 2015
DEUTSCH ENGLISH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS
1.2 Symbols and terms
Symbols used:
Warning notice. This symbol indicates possible dangers.
Please pay especially close attention to these instructions!
A note, which also refers to a course of action, provides information
about special attributes or describes set-up procedures
Notice on important information
Symbols of the Transmitter SD2T
General transmitter symbol
Transmitter not active
Transmitter active
Symbols for Receiver SD2R
General receiver symbol
The receiver’s active protective field is not free. Outputs in OFF state
The receiver’s active protective field is free. Outputs in ON state
The receiver’s active protective field is free. Outputs in OFF state
Signal output
Signal input
Signal input and/or output
Table 1.2-1: Symbols