General
Leuze electronic SOLID-2 7
TNT 35/7-24V
Review-Stand, , 8. April 2015
DEUTSCHENGLISHFRANÇAISITALIANOESPAÑOLNEDERLANDS
Terms used in this manual:
AOPD Active Opto-electronic Protective Device
AutoReset After an error indication, for example because of a faulty
external wiring, the AOPD attempts to start again. If the
error is no longer present, the AOPD returns to normal state.
Contactor monitoring
(EDM)
Also called External Device Monitoring (EDM), monitors
dynamically the positive-guided normally closed contacts of
downstream relays, contactors or valves
OSSD1, OSSD2 Safety-related switch output
Output Signal Switching Device
RES Start/REStart interlock
Response time of AOPD The time lag between penetration into the active protective field
of the AOPD and the actual switching off of the OSSDs
Scan All beams, beginning with the synchronization beam, are
pulsed by the transmitter in cycles one after the other
Start/restart interlock
(RES)
Prevents automatic start after the supply voltage has been
turned on, or after the protective field has been penetrated
TC1 Transmission channel 1
TC2 Transmission channel 2
Table 1.2-2: Terms
To Next Page
Loading...
