LevelOne WAB-7400 - Page 50

49
Figure 9.2.1: SNMP configuration page
SNMP configuration page contains the following parameters:
 Active: Enable or disable SNMP management.
 Version: Select “v1 or v2c”, “v3”, or “all” SNMP version.
 Port: Enter the SNMP port number.
 v2 Read Community: Enter the v2 Read Community.
 Reconfirm v2 Read Community: Re-enter v2 Read Community to verify.
 v2 Read-write Community: Enter the v2 Read-write Community.
 Reconfirm v2 Read-write Community: Re-enter v2 Read-write Community
for verification.