5-5
MIDI Operation
PCM 81
CONTROLLING THE SOFT KNOB WITH MIDI
Each PCM 81 preset has a unique soft knob patch that allows you
to control the effect directly from Program or Register Banks mode
with the ADJUST knob. You can also control the soft knob patch
remotely from MIDI, or from the Foot Pedal.
To control the soft knob with
MIDI, set Control mode 3.1
(Receive) to the desired MIDI
Channel. Set Control mode 3.5
(ADJUST) to the desired MIDI
Controller such as Mod Wheel.
Now, the Mod Wheel on the MIDI instrument will control the soft
knob patch of the running effect.
CONTROLLING THE SOFT KNOB WITH A FOOT
PEDAL
If you have a foot pedal connected to the PCM rear panel Foot
Controller jack, you can use it to control the soft knob patch. (Note
that no MIDI connections are required to do this.)
Set both Control mode 3.5
ADJUST and Control mode 3.5
Foot Pedal to the same MIDI
Controller.
Now, the foot pedal will control
the soft knob patch of the
running effect.
PROGRAM CHANGE MESSAGES
Reception of MIDI Program Change and Bank Select messages can
be selectively enabled/disabled from Control Mode parameter 3.0,
MIDI Pgm Change. The manner in which the PCM 81 interprets
these messages is determined by the value of this parameter as
follows:
Pgm Change: Off
All Program Change and Bank select messages are ignored. Pgm+
and Pgm– will load the next higher or lower program in the
current bank.
Pgm Change: On
Program Change messages 0-49 correspond to PCM 81 Effects 0.0
-4.9 in the current bank. Program Change messages 50—127 are
ignored. Pgm+ and Pgm– will load the next higher or lower
program in the current bank.
The current bank can be changed with MIDI Bank Select Messages
as follows:
0-5: Program Banks 0-5
6: Internal Register Bank
7-11: reserved
12-58: Memory Card Banks
. . . continued on page 5-6
MIDI ✱ADJUST
3.5 Send Mod Wheel
MIDI ✱ADJUST
3.5 Send Ctl 3
MIDI ✱Foot Pedal
3.5 Send Ctl 3
To Next Page
Loading...
