Lexicon PCM 81 - REV 2 - Selecting a Bank and Register Location; The Full Edit Matrix

2-26
Basic Operation
Lexicon
Selecting a Bank and Register Location
Press Load/✱ to move the asterisk to the Register Bank ID.
THE FULL EDIT MATRIX
Setting Edit Mode to Pro (Control Mode 1.0) gives you access to
the full parameter matrix of the algorithm for any loaded effect
whenever you press the front panel Edit button.
To select any parameter for adjustment, use SELECT to move
horizontally across the matrix and the Up and Down buttons to
move vertically. An asterisk (✱) appearing before a displayed
parameter indicates that more than one parameter is available at
that location. Press Load/ ✱ to display these additional parameters.
Each of the 17 PCM 81 algorithms has a unique matrix, but many
parameters are common to all effects, and their placement within
the matrix is consistent. For example, all parameters within a given
row of any matrix are related. This type of grouping is immediate-
ly apparent from the name of the row. For example the "Levels"
row in any matrix will contain all of the available level controls for
the effect's delay voices.
As far as possible, rows with similar controls will always appear in
the same position in the matrix and, within each row, parameters
will generally appear in the same position. For example, the first
row (0) in every algorithm is "Controls". The Mix parameter, which
is available in all effects, is always located in position 0 in this row.
Similarly, the last two rows of every matrix are "Modulation" and
Patches". This makes it very easy to find your way around the large
number of available parameters, and to anticipate where to find
the controls you are looking for when you switch between effects.
Detailed information about each individual edit matrix, as well as
parameter and effect descriptions are given in Chapter 3.
When the asterisk is positioned in front
of the Bank ID, ADJUST or SELECT will
scroll through available register banks.
ADJUST: EfxRvb X
✱R 0.0 available
When the asterisk is positioned in front
of the register matrix location, ADJUST
or SELECT will scroll through the
available registers.
ADJUST: EfxRvb X
R ✱ 0.0 available
Press Load/✱ again to move the asterisk to the register matrix
location.
Once you have made all the changes you want to an effect, and
have selected a register location, press Store. If you press Store, the
display will ask "Are you sure?" (Press STORE). If you don't want to
save the effect as shown, press any button to cancel the operation.
Press Store to complete the operation.