2-16
Basic Operation
Lexicon
ROW 5 MAPX
Map 0 and Map 1
When Control mode 3.3 is set to Map, received MIDI Program
Change messages will be mapped according to the selections
made here. The selections available are: MIDI Program Change #
(0-127), Bank # (PCM 81 preset, register, or card bank) and Pgm #
(PCM 81 effect number 0-49). When shipped, the PCM 81 has the
two internal maps configured to access all presets and registers:
Map 0 Map 1
MIDI 0 = P0 0.0 MIDI 0 = P2 2.8
MIDI 127 = P2 2.7 MIDI 121 = R 4.9
ROW 6 CHAIN
The PCM 81 has 10 internal program chains, numbered 0-9. (Ten
additional chains are available if a register card is inserted.) Each
chain is made up of 10 "links" (numbered 0-9). You can assign any
program or register to any link in the chain.
A chain can be loaded with a MIDI Program Change message, or
by selecting its number directly at Control mode 3.3. Once a chain
is loaded, the source assigned to Pgm+ and Pgm– will load the next
higher or lower program in the chain.
Pgm Assign
When Control mode 3.3 is set to Chain, received MIDI Program
Change messages will be mapped according to the selections
made here. Two assignments are available: MIDI Program Change
# (0-127) and Chain # (0-9). When the PCM 81 is shipped, all
program numbers are mapped to Chain #0. To change
assignments, set Pgm#, with ADJUST, press Load/✱ to move the ✱
to Chain# and set it with ADJUST. (You cannot assign more than
one chain/MIDI #.)
Chain Pgm Assign
Pgm#: ✱ 3 Chain#: 3
Chain 3 Prime Blue
Link#: ✱ 0 P0 0.0
Chain 0-9
Use SELECT to choose a chain. Once a chain is selected, any PCM
81 program or register can be assigned to any link in the chain.
Press Load/✱ to move the ✱ from Link# to the Bank ID, to the
program number. Depending on the field marked with the ✱,
ADJUST will select link numbers 0-9, Banks (Pn or Rn), or the
desired program within the displayed bank.
To Next Page
Loading...
