2-15
Basic Operation
PCM 81
3.9 Dump Speed
Turn ADJUST to select dump speeds of Slow, Medium or Fast to
achieve compatibility with the connected MIDI device.
ROW 4 SETUP
4.0 STORE
Control mode Audio, System, and MIDI parameter settings, along
with two settings from the Tempo matrix, comprise a "Setup." Five
setups can be stored in the unit, or on a Memory Card, allowing
you to transport not only your effects, but complete PCM 81
environments to another PCM 81. Press Store to initiate the Setup
Store function.
When the PCM 81 is shipped (or when you reinitialize the unit)
default values are assigned to these parameters. The following
table shows the Setup parameters along with the factory default
setting of each parameter.
4.1 Load
This control allows you to load your stored setup, restore the
default setup shown at the right, or load a setup from a Memory
Card.
Control Mode
Matrix Location System Parameter Default Setting
Audio 0.0 Word Clock Internal 48kHz
0.1 Analog Lvl 100%
0.2 Digital Lvl 0%
0.3 Word Size 20 bits
0.4 SCMS Multi Copy
0.5 Emphasis Bit Pass Thru
0.6 Output Level +4dBu
System 1.0 Edit Mode Go
1.1 Mix Mode Pgm
Global Mix Value 100% Wet
1.2 Tempo Mode Pgm
Global Tempo Value 120 BPM
1.3 Bypass Mode InputMute
Bypass Src Off
1.4 Pgm Bypass AllMute
1.5 Mem Protect On
1.6 Auto Lock Off
1.7 Patch Update Delayed
MIDI 3.1 Receive OMNI
3.2 Transmit 1
3.3 Pgm Change On
Pgm+ Off
Pgm– Off
Map select 0
Chain MIDI
3.4 Automation Off
3.5 Footpedal None
Sw 1 None
Sw 2 None
ADJUST None
3.6 Int Clock Off
3.7 SysEx On
Device ID 0
3.9 Dump Speed Slow
Tempo Mode
Matrix Location System Parameter Default Setting
Tempo 0.2 Source Internal
Tap 1.3 Display On
To Next Page
Loading...
