2-35
Basic Operation
PCM 81
Adjusting the Modulation Source Parameters
Continuing the previous example, we’ll adjust the rate of the LFO
by jumping to it from the Patch row.
Press Load/✱ repeatedly to return to the Patch 1 Source selection
display.
Now, press Edit to jump back to your previous position in the Patch
row.
Patch 1 ✱ Src
Int LFO
Press Edit to jump directly to the LFO parameters in the Mod row.
The asterisk (
✱
) indicates that LFO Rate will be altered when you turn
ADJUST. Press Load/✱ to change the selection to the other LFO parameters
(Shape, P Width, and Depth).
Patch Source
Indicator
■ Mod : LFO ✱ Rate
8.0 0.21Hz
The display now shows position 8.0 in the Edit matrix Mod Row.
The small square in the upper left corner of the display is a patch
source indicator. This indicator appears whenever a modulator
(such as the LFO in this example) has been assigned as a patch
Source in the effect being edited.
Turn ADJUST to change the LFO rate to 0.10Hz.
■ Mod : LFO ✱ Rate
8.0 0.10Hz
Patch 1 ✱ Src
Int LFO
Changing the Default Destination Values
Let’s modify the patch further by adjusting the Destination values
to a more useful range.
Press Load/✱ repeatedly until the Patch 1 Values screen is
displayed.
Patch 1 Values
✱ 000 -360 Mono
Notice that the ✱ is to the left of the Source value. This indicates
that the Source value is selected and its value will be changed when
you turn ADJUST.
To Next Page
Loading...
