2-13
Basic Operation
PCM 81
ROW 3 MIDI
3.0 Reset
This control resets all patched parameters to their previously stored
values. When this control is activated, a MIDI "Reset All Controllers"
message is also transmitted on the current channel by the PCM 81.
3.1 Receive
Use ADJUST to select OFF, 1-16, or OMNI for receipt of MIDI mes-
sages.
3.2 Transmit
Use ADJUST to select OFF or 1-16 for transmission of MIDI messages.
3.3 Pgm Change
This control specifies the PCM 81's response to incoming MIDI
Program Change messages. There are four selections available via
ADJUST: On, Off, Map and Chain. Pgm+ and Pgm – are available
as subparameters in each location. Pgm+ loads the next higher
effect in the current bank, map , or chain. Pgm – loads the next
lower effect. The following sources activate Pgm+ and Pgm –:
Off
Footswitch 1
Footswitch 2
•
•
•
MIDI Controller #119.
On
Program Change messages 0—49 correspond to PCM 81 Effects
0.0 —4.9 in the current bank. Program Change messages 50—127
are ignored. The current bank can be changed with MIDI Bank
Select Messages as follows:
• 0–5: Program Banks 0–5
• 6: Internal Register Bank
• 7–11: reserved
• 12–58: Memory Card Banks. The number of banks
available on a given card will vary with its size,
as follows:
Card Size # Banks
64 2
256 11
512 23
1 Meg 47
Off
All Program Change and Bank select messages are ignored.
Map
Program Change 0-127 can be mapped to any PCM 81 effect in
any internal or card bank. Two 128 element maps are stored
internally, additional maps may be stored on RAM cards. Once you
have selected Map, press Load/✱ to display:
To Next Page
Loading...
