3-20
Algorithms and Parameters
Lexicon
FILTERS
In the M-Band+Rvb algorithm, Row 5 contains parameters for
cut-off frequencies of low and high cut filters for each voice, as well
as master low and high cut controls for all voices.
Mstr LC/HC
Two master controls are provided in the first row position. Press
Load/✱ to toggle between them. The High Cut Master allows
simultaneous adjustment of the high frequency cut-off points for
the filters on all voices in single semitone increments up or down
from the individual voice settings. The Low Cut Master allows
simultaneous adjustment of the low frequency cut off points for the
filters on all voices in single semitone increments up or down from
the individual voice settings.
V1-V6 LoCut and HiCut
The low cut and high cut filters operate at 12dB/octave. Each of six
voices has individual low cut and high cut filters. The ranges of the
filter cut-off points are from 20-20,000Hz at approximately
semitone intervals across the entire range for a total of 121 cut off
points. The low cut filters have an OFF position just below 20Hz.
The high cut filters have an OFF position just above 20,000Hz.
GLIDE FX
In the Glide>Hall algorithm, Row 3 contains level, delay and
feedback parameters for a pair of stereo gliding delays that
preceded the 6-voice delay.
Gld Lvl
Gld Lvl controls the stereo output level from all gliding delays (A,
B, Left and Right). It has a range of Full (0dB) down to -85dB and
Off.
A Left (A Lvl L and A Dly L)
These parameters control the output level and delay time of the left
channel A Glide Delay. A Lvl L has a range of Full (+0dB), Phase
Normal down to -85dB, Phase Normal, OFF, -85dB Phase Inverted
up to Full (+0dB), Phase Inverted. A Dly L has a range of 0.0
milliseconds to 42.0 milliseconds in 0.1 millisecond units.
A Right (A Lvl R and A Dly R)
These parameters control the output level and delay time of the
right channel A Glide Delay. They have the same ranges as A Left.
B Left (B Lvl L and B Dly L)
These parameters control the output level and delay time of the left
channel B Glide Delay. They have the same ranges as A Left.
B Right (B Lvl R and B Dly R)
These parameters control the output level and delay time of the
right channel B Glide Delay. They have the same ranges as A Left.
Fbk L/R
These parameters control the feedback levels of the corresponding
left and right channel Glide Delays. The range of these parameters
is from +100% down to 1% (Phase Normal feedback), 0% (off),
-1% up to –100% (Phase Inverted feedback).
X-Fbk L/R
These parameters control the corresponding cross feedback levels
of the left and right channel glide delays. Specifically, X-Fbk L
controls the feedback from the left channel A+B glide delay output
to the right channel glide delay feedback input. X-Fbk R controls
the feedback from the right channel A+B glide delay output to the
To Next Page
Loading...
