3-26
Algorithms and Parameters
Lexicon
PATCHING (continued)
Values
Use ADJUST to assign Destination values to specific Source values.
These assignments are made in pairs, each with a value for the
Source and a value for the Destination. For example, the default is
two pairs mapped as follows:
• minimum Source value (0) = minimum Destination value
• maximum Source value (127) = maximum Destination value
This gives you a linear relationship between the parameter and the
controller. Inverse control is accomplished easily by reversing these
settings. As many as eight pairs of Destination/ Source values can
be assigned here, providing an exciting new level of dynamic
control.
See Chapter 2 for a complete description of the Patching System.
LFO
Sine
Cosine
Square
Sawtooth
Pulse
Triangle
Env L
Env R
AR Env
Latch
Sw 1
Sw 2
Sw 1 & 2
Mono Lvl
Left Lvl
Right Lvl
Footpedal
Foot Sw 1
Foot Sw 2
ADJUST
Tempo
On
Off
Internal
(PCM 81 interprets
000 as Bank Select)
001 Mod Wheel
002 Breath
003 Ctl 3
004 Foot Ctl
005 PortaTime
006 Data Entry
007 Volume
008 Balance
009 Ctl 9
010 Pan
011 Xpression
012 Effect 1
013 Effect 2
014 Ctl 14
015 Ctl 15
016 General 1
017 General 2
018 General 3
019 General 4
020 Ctl 20
031 Ctl 31
(PCM 81 interprets
032 as Bank Select)
033 Ctl 33
063 Ctl 63
064 Sustain
065 Porta On
066 Sostenuto
067 SoftPedal
068 Legato
069 Hold 2
070 Sound Var
071 Timbre
072 Release
073 Attack
074 Bright
075 Sound 6
076 Sound 7
077 Sound 8
078 Sound 9
079 Sound 10
080 General 5
081 General 6
082 General 7
083 General 8
084 Porta Ctl
085 Ctl 85
090 Ctl 90
091 FX1 Depth
092 FX2 Depth
093 FX3 Depth
094 FX4 Depth
095 FX5 Depth
096 Data Inc
097 Data Dec
098 NRPN LSB
099 NRPN MSB
100 RPN LSB
101 RPN MSB
102 Ctl 102
119 Ctl 119
MIDI Controller Numbers
P Bend
A Touch
Velocity
Last Note
Low Note
High Note
Clk Comnds
MIDI
To Next Page
Loading...
